not even EE

Did some DIY on the heater power mains plug, the plastic part of the plug was extruding outwards and limited the wooden cupboard's alignment with the wall, therefore some slight modifications fixed this.cut the big ugly ends off, and thou shalt expose 3 internal wires, active, neutral and earth.

Active = Red or Brown

Neutral = Black or Blue

Earth = Green and yellow

Strip the outer plastic insulation until the 3 wires are about 10cm in length, and start wiring!

Make sure the wires are attached to their respective pins on the new plug end, and all wires are tucked neatly so the case closes properly.

and hey presto.

no more annoyingly-big-power-plugs-that-causes-cupboards-to-not-be-flush-with-walls business.

tune in later for more of this kinda shit.